|PageViews: 100,736 hits / 600 nets|
HTMUX parameter == HTMUX=sv[:[hostList][:portList]] | HTMUX=cl:host:port | HTMUX=px:host:port -- restriction: requires CAPSKEY -- default: none
Not only incoming connections but also outgoing connections from a HTMUX client is established via the HTMUX server by default. This might not necessary for a DeleGate that relays incoming request to internal server. In such case, use the CONNECT parameter to specify such connections to be established directory, as CONNECT="direct:*:192.168.1.*" for example.
This example implies that hostX is a multi-homed host with a private addresses 192.168.1.1 and a global address xx.xx.xx.xx. The DeleGate on hostX acts as a HTMUX server. HTTP DeleGate on hostI and FTP DeleGate on hostJ act as HTMUX client which remotely accepts requests (arrived at xx.xx.xx.xx) via the HTMUX server on HostX.
A pair of HTMUX server and client uses a single persistent connection to relay
multiple parallel connections on it multiplexing them by the
This feature must not be exploited maliciously, for example to invite incoming connections violating a restriction on a firewall. Therefore you need to install CAPSKEY to enable this feature. Other usages of HTMUX being disabled by default are non-direct connection between client and server (connection via NAT or proxy), too large clock skew between client and server (300 seconds by default), or inserting SSL encryption between client and server.
The persistent connection between HTMUX client and server is capable to convey connections bi-directionally, thus can be used to make a pair of proxies over it. Each proxy accepts requests at the local port and forwards them to the remote peer as the following example.
Example: using HTMUX to make symmetric proxies (the simplest generic configuration)
In this example, -P8080 is equivalent to a wild-card address expression
"-P*:8080" to accept from the port number 8080 on any network interfaces
on the host.
Therefore requests to the port 8080 on any interface on hostX is forwarded
to the servers via the DeleGate on hostY as a HTMUX client (and a HTTP proxy).
Symmetrically, requests to the port 8080 on any interface on hostY is
forwarded to the servers via the DeleGate on hostX as a HTTP proxy (and a
HTMUX server at hostX:9876).
(Again, note that this feature is disabled by default and needs CAPSKEY to enable it)
The port to be used on the server side and on the client side can be specified separately with the "/local" and "/remote" modifiers for -P or -Q option. "/local" marks a port to be used on the local host (on a HTMUX client), and "/remote" marks the port to be used on the remote host (on a HTMUX server). The specification "-P8080" in the above example is equivalent to "-P*:8080/remote,*:8080/local".
Example: using HTMUX bi-directionally
In this example, between hostX and hostI, requests to localhost:8081 on each host are forwarded to the peer (equivalent to "-Plocalhost:8081/remote,localhost:8081/local") Between hostX and hostJ, hostX:8082 and hostJ:8083 are forwarded to the peer (equivalent to "-PhostX:8082/remote,hostJ:8083/local")
Example: using HTMUX only for outbound requests
This is an example to use HTMUX only for outbound requests. It works even without the HTMUX parameter, but with HTMUX, a single persistent connection is used between the server and client. This usage of HTMUX is enabled by default when DeleGate is executed in foreground (with -fv option, running not as a service or a daemon), without restrictions described as above, and don't require CAPSKEY.